How to Install the ARRIS SURFboard Modem (SB6141)

The Basic Information On How To Set Up, Install And Connect The Cable Modem
Before you install the Comcast cable modem, you have to look to verify that a coaxial cable already exists which will be connected to a cable outlet in the wall. Once you check, next join the opposite end of the coaxial cable to the cable device linking one to the another. This will be found on the rear of your Arris surfboard. Coaxial cables have inner conductors encased by many insulating coverings. Use your hand to seal the connectors by doing this process you will eliminate doing any damage to them. The second step to install the Comcast cable modem, you need to connect the Ethernet cable directly to the Ethernet opening first on your computer and next to the Ethernet portal which is located on the back of your Arris surfboard.

An Ethernet cable is one of the most favored designs of network on cable used wired system. The Ethernet port is an outlet on a computer network machines that ethernet cables push inside. The last instruction for positioning the cable modem is you will need to connect the power cord to the power port. The power port is situated on the rear of your sb6190. After insert the other end into an electric outlet in the wall. Know that is not managed by a wall switch. This automatically turns on your sb6190. Once you have gone through those steps, test the cable modem hookup. Power on your computer. The receive, send as well as the online LEDs on your sb6190 will flash, within a few seconds the light will be consistent. If there is a problem and if all three LEDs do not come on and remain solid it will be necessary to contact your internet service provider. If the site you are searching for opens with no problems, your sb6190 was set up accurately.

Share Button

Comments closed